900 SE Sedan V6-2498cc 2.5L DOHC (1995)
5. Install the rubber bushes and retaining nuts for the anti-roll bar (6).
Tightening torque: 10 Nm (7.4 ft. lbs.).
6. Tighten the retaining bolts for the anti-roll bar clamps.
Tightening torque: 26 Nm (19.2 ft. lbs.).
7. Raise the sub-frame at the rear and install the four retaining bolts (4) and the two retaining nuts (5). The washers on the rear retaining bolts should
abut against the body.
8. Tighten the front retaining bolts (3).
Tightening torque: 115 Nm (84.9 ft. lbs.).
9. Remove the steel wire and install the exhaust pipe in place (2).
10. Lower the car to the ground and remove special tools power unit yoke (1).
