900 SE Sedan V6-2498cc 2.5L DOHC (1995)
-
The O-ring should be placed between the spherical socket and the housing.
2. Install the screw which secures the gear rod to the gear lever.
-
Turn the rod so that the hole for the locking pin faces upwards.
-
Tightening torque: 18-22 Nm (13.5-16.5 ft. lbs.)
3. Install the stop.
4. Insert the locking plate.
-
Check that the locking plate's two bearings (rubber bushing and hat) in the housing are in place.
5. Clip the ignition lock's rider into the locking plate.
6. Install the locking plate holder.
-
The screws which secure the locking plate holder should be coated with thread locking fluid.
7. Install the locking plate spring.
8. Adjust the position on the locking plate with the screw on the locking plate holder so that the locking plate is level with the heel in the gear lever
housing.
NOTE: The stop may not touch the locking plate during the adjustment.
9. Install the entire gear lever housing and gear rod.