900 Turbo Convertible L4-1985cc 2.0L DOHC Turbo EFI (1994)
2. Fasten a new tie to the cables under the heat shield.
3. Install the cables to the rear guide sleeves and the levers.
4. Install the springs to the levers.
5. Install the pull rod adjustment nut to the previously measured thread length.
6. Pull the tank strap tight.
7. Lower the car and set the handbrake to the 2nd notch.
8. Lift the car and tighten the pull rod adjusting nut until the brakes start to act.
9. Lower the car, release the handbrake and then operate it again. The wheels should lock at the 6th notch.
10. Lift the car and fasten the center heat shield.
11. Fasten the rear heat shield.
12. Install the back wheels and tighten the wheel studs.
-
Tighten to: light alloy wheels 117 Nm (86.6 ft lb).
-
Tighten to: pressed steel wheels 100 Nm (74 ft lb).
