900 Turbo Convertible L4-1985cc 2.0L DOHC Turbo EFI (1994)
^
CHECK FAN BELT
^
WASHER FLUID LEVEL LOW
^
COOLANT LEVEL LOW
^
TIME FOR SERVICE After a CHECK function has become active the driver must confirm that the message has been received, as follows:
^
acknowledging with the action indicated in the text for the three top-priority messages
^
pressing any button except the BLACK PANEL button for other messages.
After confirmation, the CHECK function will not be shown until the ignition is switched off and on again.
Units and languages
The SID unit contains four different combinations of units:
^
Liter/100 km + °C
^
miles/gallon (imp.) + °F
^
miles/gallon (imp.) + °C
^
miles/gallon (US) + °F
The side instrument contains six different languages:
^
Swedish
^
English
^
German
^
French
^
Italian
^
Spanish
SID unit 2: Press the "INFO" and "CLEAR" buttons simultaneously for more than 2 seconds to enter the unit and language mode.
Use the INFO button to change the units and the CLEAR button to change the language.
To finish, wait for more than five seconds after the last selection or switch off the ignition.
Sid unit 3: Press the "CLEAR" and "SET" buttons simultaneously for more than 2 seconds to enter the unit and language mode.
Use the (-) button to change the units and the (+) button to change the language.
To finish, acknowledge the change with the SET button, wait for more than five seconds after the last selection or switch off the ignition.
Sounds
The SID unit generates different types of sound for different functions.
The different functions are:
^
Warning
^
Time alarm (SID unit 3)
^
Speed warning (SID unit 3)
^
Reminder (warning, ignition key and seat-belt)
^
Confirmation (after pressing button)
^
Direction indicators (TICK TACK)
BLACK PANEL
Instrument lighting is dimmed by pressing the BLACK PANEL button.
The SID unit's display lights up only if a CHECK function is activated and then remains alight for 10 seconds, after which it goes out.
If the driver acknowledges the message, the display will go out immediately unless the BLACK PANEL button is pressed again.
The SID unit also lights up if any trip computer button is pressed and then remains alight for 10 seconds after the last button was pressed.
If any of the audio unit's buttons is pressed, the display will light up and then remain alight for 5 seconds after the last button was pressed.
Trip Computer
The trip computer has the following functions: (left-hand side <)
^
TEMP (outside temperature).
^
D.T.E (distance on remaining fuel).
^
FUEL @ (average fuel consumption).
^
Alarm (time alarm, SID unit 3 only). (right-hand side >)
^
DIST (distance to destination, SID unit 3 only).
^
ARRIV (time of arrival, SID unit 3 only).
^
SPD @ (average speed, SID unit 3 only).
