900 Turbo Convertible L4-1985cc 2.0L DOHC Turbo EFI (1994)
4. Screw the seal holder and its shims in position. Tighten alternately to 20-24 Nm (14.5-17.5 ft. lbs.).
-
Adjust the bearing pre-stress (refer to the Assembly procedure found under Overhaul. See: Service and Repair
In Vehicle
1. Remove the drive shaft on the lefthand side and the drive shaft and intermediate shaft on the righthand side. Refer to Steering and Suspension.
2. Remove the five screws which hold the seal holder.
3. Carefully pry out the seal holder with two large screwdrivers. Put the shims in a safe place.
4. Replace the sealing ring and O-ring.
5. Install the shims and carefully tap in the seal holder. Tighten the screws to 20-24 Nm (14.5-17.5 ft. lbs.).
6. Install the drive shafts.