900 Turbo Convertible L4-1985cc 2.0L DOHC Turbo EFI (1994)
3.
Remove the license plate lights and disconnect the leads. See Figure 1-3.
4.
Remove the mercury switch. See Figure 1-2. Save the screw, washer and clip.
5.
Unplug the connector for the central locking motor. Carefully mark the leads, noting their positions in the connector. Remove the leads from the
connector and tape them together. See Figure 1-1.
6.
Cut the three cable ties securing the wiring at the trunk lid and hinge arm. See Figure 1-4.
Remove the clip on the hinge arm and the one in front of the hinge.
Save the clips.
7.
Unplug the connector for the high-level brake light. See Figure 1-5.
8.
Carefully remove the wiring from the trunk lid.
9.
Wrap tape around the sharp edges of the mercury switch connector so that it will pass easily through the cable sheathing.
10.
Locate the black lead for the interior lighting at the connectors at the front of the trunk wiring by the inner side panel. See Figure 2-3.
Pull the lead out of the sheathing.
11.
Refit the wiring in the trunk lid, reconnect the brake light and license plate lights.
