900 Turbo Convertible L4-1985cc 2.0L DOHC Turbo EFI (1994)
Refit the leads in the connector for the central locking motor, brown/white lead to brown/white lead and blue lead to violet lead.
12.
Secure the ground lead for the license plate lights with the screw, washer and clip previously used for the mercury switch.
13.
Adjust the position of the wiring for the trunk lid. Attach it with cable ties.
Attach two of the cable ties at the markings on the hinge arm. Attach the wiring to the grounding point for the license plate lights in the trunk lid
with the third cable tie.
Refit the clips, one on the hinge arm and the other on the upper edge of the inner side panel just in front of and above the hinge arm mounting
point. (See Figure 4.)
14.
Remove the sealing strip for the trunk lid, beginning at the joint in the middle of the wiring and continuing all the way up to the top left corner.
Remove the screws from the cover over the rear bumper abutment and left-hand side trim.
Remove the cover and fold back the side trim as much as possible.
15.
Pull the lead for the interior lighting through the front hole in the inner side panel.
Secure the lead along the side panel up to the hole using approximately l5Omm of insulating tape. Then run it alongside the antenna cable,
continuing along the lead for the electric antenna as far as the left-hand rear light cluster.
Wrap the surplus lead with insulating tape.
