saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Antenna Cable Replacement (Coupe)|Page 10390 > < Antenna Cable Replacement (Coupe)|Page 10388
Page 7
background image

11. Disconnect the antenna cable from I/P padding wiring harness.

Disconnect and insulate the wiring harness (1).

Installation Procedure

1. Connect the wiring harness plug of the roof aerial.
2. Install headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan)   (See: Body and Frame/Interior Moulding /

Trim/Headliner/Service and Repair)Headlining Trim Panel Replacement (With Sunroof)   (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair)Headlining Trim Panel Replacement (Coupe)   (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair).

3. Remove the rear compartment side trim panel. Refer to Rear Compartment Side Trim Panel Replacement (Coupe)   (See: Body and Frame/Interior

Moulding / Trim/Trim Panel/Service and Repair)Rear Compartment Side Trim Panel Replacement (Sedan)   (See: Body and Frame/Interior
Moulding / Trim/Trim Panel/Service and Repair).

4. Install the radio.

*

Connect the 2 wiring harness plugs.

*

Push the radio into the holder until it engages.

5. Install the I/P compartment.

Connect the wiring harness plug.

Caution:  Refer to Fastener Caution   (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).

6. Install the I/P compartment.

Tighten the 4 screws to 4 Nm (35 lb in).

Close the I/P compartment door.

7. Install the door sill inner panel.

Clip in the 5 clips.

8. Connect the battery.
9. For reprogramming procedures, refer to Control Module References   (See: Testing and Inspection/Programming and Relearning).

Antenna Cable Replacement (Coupe)|Page 10390 > < Antenna Cable Replacement (Coupe)|Page 10388