Astra L4-1.8L (2009)
6. Install the diagnostics plug bracket.
1. Install the bracket and tighten the 3 nuts to 10 Nm (89 lb in).
2. Clip in the clip.
7. Install the yaw sensor and tighten the 2 nuts to 6 Nm (53 lb in).
8. Connect the wiring harness plug.
9. Install the air bag control unit.
Connect and lock the 2 wiring harness plugs and tighten the 3 nuts to 10 Nm (89 lb in).
10. Install the left and right I/P insulator panels.
*
Insert the I/P insulator panels bracket and 2 screws on the drivers side.
*
Insert the I/P insulator panels bracket and 2 screws on the passengers side.
11. Install both sides of the rear quarter panel.
12. Clip in the 8 rear quarter panel clips.
*
Tighten the bolt on upper center pillar to 2.5 Nm (22 lb in).
*
Tighten the bolt to rear seat backrest to 40 Nm (30 lb ft).
*
Tighten the lower center pillar bolt to 35 Nm (26 lb ft).
13. Install the rear quarter panel cover cap front.
14. Install the belt striker guide bushing to rear quarter panel front.
15. Install the seat belt with striker.
16. Install the lower belt striker and tighten the lower belt fastening bolt to 35 Nm (26 lb ft).
17. Install both sides of the upper center pillar panelling.
1. Guide the center pillar panelling from above in inner panelling guide front of rear quarter panel.
2. Clip in the upper center pillar panelling.
3. Press in the expanding bolt and tighten the seat belt bolt to center pillar to 35 Nm (26 lb ft).
4. Clip in the cover cap.
18. Install both door trim plates.
19. Insert the rear seat backrest into side guide.
Note: Use the screw locking compound.
20. Install the rear seat backrest and tighten the 3 rear bolts to 20 Nm (15 lb ft).
21. Fold the down rear seat backrest and tighten the front 3 bolts to seat belt buckle to 20 Nm (15 lb ft).
22. Install the bench seat.
1. Install the 2 seats in the rear bracket.
2. Push the seat simultaneously backwards and down.
3. Bolt the front 2 brackets.
23. Install the front floor console. Refer to Front Floor Console Replacement (See: Console/Service and Repair).
24. Insert the driver side front seat.
1. Connect and latch the compact connector.
2. Insert the seat in the front guide.
Note: Use screw locking compound.
25. Fasten the driver side front seat and tighten the 2 bolts 35 Nm (26 lb ft).
Note: Use screw locking compound.
26. Insert the passenger side front seat.
1. Connect and latch the compact connector.
2. Insert the seat in the front guide and tighten the 2 bolt 35 Nm (26 lb ft).
27. Connect the battery.
28. For programming procedures, refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
