Astra L4-1.8L (2009)
Tighten the 4 bolts to 35 Nm (26 lb ft).
3. Position wiring harness for seat heating, if equipped.
Secure with 4 cable ties.
4. Position the airbag cable harness.
5. Install the central wiring harness plug for the seat.
Install the plug.
6. Install the interior paneling.
Insert the paneling.
Tighten the bolt to 2.5 Nm (22 lb in).
7. Install the exterior paneling.
Insert the paneling.
Tighten the 2 bolts to 35 Nm (26 lb ft).
8. Install the rear seat backrest adjuster wheel.
Install the adjusting wheel.
9. Install the height adjuster.
Tighten the 2 bolts to 35 Nm (26 lb ft).
10. Install the height adjuster panel.
Clip in panel.
Note: Ensure correct wiring harness routing.
11. Insert the side airbag.
Connect and latch the wiring harness plug.
12. Fasten the side airbag.
Tighten the 3 bolts to 5 Nm (44 lb in).
13. Fasten the front seat backrest paneling.
*
Re-install the 2 clamps.
*
Fasten paneling all round.
Note: Connect the wiring harness plug.
14. Install the front seat.
Insert into front guide.
15. Install the front seat, rear.
Tighten the 2 bolts to 35 Nm (26 lb ft).
16. Reposition the seat to the original position.
17. Install the seat belt at the front seat.
Tighten the bolt to 20 Nm (15 lb ft).
18. Install the seat belt fastening panel.
19. Connect the battery.
20. For programming procedures, refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
Front Seat Cushion Inner Trim Panel Replacement
Front Seat Cushion Inner Trim Panel Replacement
Removal Procedure
Warning: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
