Astra L4-1.8L (2009)
3. Remove the filter with a blunt tool.
10. Install the camshaft position actuator solenoid valves and seals. Coat the seal with clean engine oil prior to installation.
11. Install the camshaft position actuator solenoid valve bolts.
Tighten
Tighten the bolts to 6 Nm (53 lb in).
12. Connect the camshaft position actuator solenoid valve connectors.
13. Reposition and install the PCV pipe (for 1.6/1.8 only).
14. Reposition the power steering bracket and install the power steering line bracket bolt (for 1.6/1.8 only).
15. Connect the negative battery cable.
Note
If an engine rattle noise is heard after removing the filters, refer to SI for further diagnostics.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
