saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Driver or Passenger Seat Side Inflatable Restraint Module Replacement|Page 10128 > < Driver or Passenger Seat Side Inflatable Restraint Module Replacement|Page 10126
Page 5
background image

3. Fasten the front seat backrest paneling.

*

Install the 2 clamps.

*

Fasten the paneling all round.

Note:  Connect the wiring harness plug.

4. Install the front seat.

Insert into the front guide.

5. Install the rear front seat.

Tighten 2 bolts 35 Nm (26 lb ft).

6. Reposition the seat to its original position.
7. Install the seat belt at the front seat.

Tighten the bolt 20 Nm (15 lb in).

8. Install the seat belt trim panel.
9. Connect the battery.

10. For programming procedures, refer to Control Module References   (See: Testing and Inspection/Programming and Relearning).

Inflatable Restraint Roof Side Rail Module Bracket Replacement

Roof Side Rail Inflatable Restraint Module Bracket Replacement

Special Tools

EL-48557  Remover

Removal Procedure

1. Remove the roof side rail inflatable restraint module. Refer to Roof Side Rail Inflatable Restraint Module Replacement (Coupe Original)   (See: 

)Roof Side Rail Inflatable Restraint Module Replacement (Coupe Replacement)   (See: )Roof Side Rail Inflatable Restraint Module Replacement
(Sedan Original)   (See: )Roof Side Rail Inflatable Restraint Module Replacement (Sedan Replacement)   (See: ).

Important:  The front fastening clip near the handle cannot be removed with EL-48557  . Remove the fastening clip with suitable pliers.

2. Remove the 6 fastening clips.

Insert the EL-48557   under the fastening clip and screw in, remove the fastening clip.

Driver or Passenger Seat Side Inflatable Restraint Module Replacement|Page 10128 > < Driver or Passenger Seat Side Inflatable Restraint Module Replacement|Page 10126