Astra L4-1.8L (2009)
7. When deploying a roof rail module, perform the following instructions:
1. Place the EL-39401-B - fixture (3) in the center of the cleared area.
2. Fill the deployment fixture with water or sand to provide sufficient stabilization of fixture during deployment.
3. Adjust and secure the fixture arms (4) to the deployment fixture (3), using the proper nuts and bolts.
4. Attach the roof rail module in the deployment fixture and securely tighten all fasteners.
8. Inspect the EL-38826 - harness and the appropriate pigtail adapter (2) for damage. Replace as needed.
9. Short the 2 SIR deployment harness leads (1) together using one banana plug seated into the other.
10. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
11. Extend the SIR deployment harness and adapter to the full length from the deployment fixture or area.
Note: On a dual stage inflator module, both connectors must be attached to the deployment harness adapter. This will ensure that both stage 1 and
stage 2 of the deployment loops are energized, regardless of the deployment state.
