Astra L4-1.8L (2009)
*
Insert the airbag module in guide.
*
Connect and latch the wiring harness plug.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Fasten the airbag module.
Tighten the bolt to 5 Nm (44 lb in).
3. Fasten the I/P padding.
Tighten the 2 bolts to 2.5 Nm (22 lb in).
Install the I/P padding cover, side.
4. Install the sill inner paneling.
Install the 5 clips.
5. Install the I/P compartment.
*
Connect the wiring harness plug.
*
Insert the I/P compartment.
Tighten the 4 bolts to 4 Nm (35 lb in).
*
Close the I/P compartment cover.
6. Connect the battery.
7. Perform the readiness inspection.
8. For programming procedures, refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
