Astra L4-1.8L (2009)
5. Remove the side airbag sensor.
*
Remove the 2 bolts.
*
Disconnect the wiring harness plug.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the sensor.
*
Connect the wiring harness plug.
Tighten the 2 bolts to 6 Nm (53 lb in).
2. Reposition the driver seat to the previous position.
3. Install the rear sill panelling.
Install the 5 clips.
4. Connect the battery.
Note: After ignition ON, the airbag system readiness indicator illuminates for 4 seconds and then goes out.
5. Preform the readiness inspection.
6. For programming procedures, refer to Control Module References (See: Testing and Inspection/Programming and Relearning).