Aura L4-2.4L (2008)
4. Install the brake hose to the strut with the brake hose nut (4).
Tighten the nut to 14 N.m (124 lb in).
5. Remove the caps or plugs from the brake pipe fitting end and the brake hose end.
6. Install the brake hose to the brake hose body bracket.
7. Install the brake hose retainer (2) over the anti-rotation tabs of the brake hose (3).
8. Connect the brake pipe fitting (1) to the brake hose (3).
9. Use a backup wrench on the brake hose (3).
10. Tighten the brake pipe fitting.
Tighten the brake pipe fitting to 20 N.m (15 lb ft).
11. Ensure that the hose does not make contact with any part of the suspension. Check the hose in extreme right and extreme left turn conditions. If the
hose makes contact, remove the hose and correct the condition.
12. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair).
13. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
14. Lower the vehicle.
