Aura L4-2.4L (2008)
5. Remove and discard the crankshaft balancer bolt.
6. Remove the crankshaft balancer.
Installation Procedure
1. Position the crankshaft balancer.
2. Install a NEW crankshaft balancer bolt.
3. Install the J 38122-A (1), and a breaker bar to the balancer in order to prevent the balancer from rotating while tightening the bolt.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
4. Tighten the crankshaft balancer bolt.
Tighten the bolt to 100 N.m (74 lb ft) plus an additional 125 degrees using the J 45059.
5. Install the engine splash shield. Refer to Engine Splash Shield Replacement - Right Side (LAT) ()Engine Splash Shield Replacement - Right Side