Aura L4-2.4L (2008)
6. Remove the J 45722 from the fuel pump module lock ring.
7. Lift the fuel pump module up slightly in order to disconnect the fuel tank vent pipe quick connect fitting (1) from the module cover. Refer to
Plastic Collar Quick Connect Fitting Service (See: Fuel Delivery and Air Induction/Fuel Line Coupler/Service and Repair/Plastic Collar Quick
Connect Fitting Service).
8. Raise the fuel pump module up from the fuel tank. Tilt the module in order to allow the fuel level sensor arm and float to clear the module
opening.
9. Remove the fuel pump module.
10. Remove and discard the fuel pump module seal.
11. Clean the fuel pump module sealing surfaces.
Installation Procedure
Caution: Drain the fuel from the fuel sender assembly into an approved container in order to reduce the risk of fire and personal injury. Never store the
fuel in an open container.
Important:
