Aura L4-2.4L (2008)
Important: Ensure that the brake and accelerator pedal adjustment position sensor is installed correctly to the bracket. The brake and
accelerator pedal adjustment position sensor has a sensing arm that must be installed over the brake pedal actuation arm to insure it is
sensing brake pedal position.
1. Install the brake and accelerator pedal adjustment position sensor (2) to the brake pedal bracket. Ensure the brake pedal position sensor tab locks
into the brake pedal bracket and the sensors arm is correctly installed.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
2. Install the brake pedal adjustment position sensor bolt (1).
Tighten the bolt to 2 N.m (18 lb in).
3. Connect the electrical connector to the brake and accelerator pedal adjustment position sensor.
4. Install the intermediate steering shaft to the steering column. Refer to Intermediate Steering Shaft Replacement (See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Intermediate Steering Shaft Replacement).
5. Install the instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair).
