Aura L4-2.4L (2008)
*
Some lock rings were manufactured with "DO NOT REUSE" stamped into them. These lock rings may be reused if they are not damaged
or warped.
*
Inspect the lock ring for damage due to improper removal or installation procedures. If damage is found, install a NEW fuel pump
module.
*
Inspect the lock ring for flatness as best as possible. If the lock ring is warped, replace the fuel pump module.
1. Clean any contamination from the male pipe ends of the fuel pump module.
2. Place a NEW fuel tank module seal onto the fuel tank.
3. Insert the fuel pump module into the fuel tank allowing the sensor arm and float to clear the module opening.
4. Lower the module down into the fuel tank until the fuel tank vent pipe quick connect fitting can be connected.
5. Connect the fuel tank vent pipe quick connect fitting (1) at the module cover. Refer to Plastic Collar Quick Connect Fitting Service (See:
Powertrain Management/Fuel Delivery and Air Induction/Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
6. Press the fuel tank module downward.
