Aura L4-2.4L (2008)
3. Adjust the toe to specification by turning the adjuster (6). Refer to Wheel Alignment Specifications (See: Specifications).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
4. Tighten the tie rod jam nut (5).
Tighten the tie rod jam nut (5) to 68 N.m (50 lb ft).
5. Re-calibrate the steering wheel position sensor. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
Rear Camber Adjustment
Rear Camber Adjustment
1. Loosen the inner lower control arm cam bolt nuts.
2. Rotate the cam bolts to the required camber specification setting. Refer to Wheel Alignment Measurement (See: Wheel Alignment Measurement).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
3. Maintain the camber setting while tightening the cam bolt nuts.
Tighten the inner lower control arm (front) bolt nut to 110 N.m (81 lb ft).
Important: Check the toe setting AFTER changing camber or caster.
4. Check the camber setting after tightening.
5. Adjust the camber setting if necessary.
Rear Toe Adjustment
Rear Toe Adjustment
