Aura L4-2.4L (2008)
1. Install the following components on the suspension crossmember if removed:
*
The radiator support brackets.
*
The stabilizer shaft-Refer to Stabilizer Shaft Replacement (See: Stabilizer Bar/Service and Repair/Front Suspension).
*
The lower control arms-Refer to Lower Control Arm Replacement (See: Control Arm/Service and Repair/Front Suspension).
*
The steering gear-Refer to Steering Gear Replacement (Electronic Power Steering) (See: Steering/Steering Gear/Service and Repair)Steering
Gear Replacement (Hydraulic Power Steering LY7) (See: Steering/Steering Gear/Service and Repair)Steering Gear Replacement (Hydraulic
Power Steering LZ4) (See: Steering/Steering Gear/Service and Repair).
2. Lower the vehicle on to the frame.
3. Install the frame reinforcements (3).
4. Install the front frame bolts. Hand tighten ONLY.
5. Install the reinforcement bolts. Hand tighten ONLY.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
6. Install the rear frame bolts (4).
Tighten the bolts to 100 N.m (74 lb ft) plus 180 degrees rotation.
7. Tighten the front frame bolts (1).
Tighten the bolts to 100 N.m (74 lb ft) plus 180 degrees rotation.
