Aura L4-2.4L (2008)
Wheel Bearing: Service and Repair
Rear Suspension
Rear Wheel Bearing and Hub Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Service Intervals).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement (See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service
and Repair/Removal and Replacement/Rear Brake Rotor Replacement).
4. Disconnect the electrical connector from the wheel speed sensor.
5. Remove the 4 wheel bearing/hub assembly nuts.
6. Remove the wheel bearing/hub assembly from the knuckle.
Installation Procedure
1. Install the wheel bearing/hub assembly to the knuckle.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
2. Install the 4 wheel bearing/hub assembly nuts.
Tighten the nuts to 63 N.m (47 lb ft).
3. Install the stabilizer link bolt at the knuckle. Refer to Stabilizer Shaft Replacement (See: Steering and Suspension/Suspension/Stabilizer