Aura L4-2.4L Hybrid (2009)
1. Install the hub and bearing assembly to the steering knuckle.
Caution: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a
standard tap. If a standard tap is used, damage to the joint threads will occur.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the 3 hub and bearing assembly bolts and tighten to 115 Nm (85 lb ft.
3. Install the wheel speed sensor connector into the bracket until the locking tabs click into place.
4. Connect the electrical connector to the wheel speed sensor.
