Aura V6-3.5L (2007)
Important
Do not over tighten the mounting bolts.
1. Partially lower the headliner enough to access these attachments, being careful not to bend or damage the headliner while performing the following
procedure. Loosen all (5) rear center mounting bolts and then re-tighten all (5) center mounting bolts at the rear of the module to 10 Nm (89 lb in).
Note that the forward 3 mounting bolts are accessed by the holes in the sunshade when the sunshade is fully closed (refer to figure 20).
Important
These screws should be snug. Do not over tighten the mounting bolts.
Figure 21
2. Tighten both rear motor attachment screws (3 per motor / 6 total) to 4 Nm (35 lb in). (refer to figure 21)
Figure 22