Aura V6-3.5L (2007)
*
If the lathe is equipped with a non-directional finishing tool, apply the finish with 120 grit aluminum oxide sandpaper
*
If the lathe is not equipped with a non-directional finishing tool, apply the finish with a sanding block and 150 grit aluminum oxide
sandpaper
3. After applying a non-directional finish, clean each friction surface of the brake rotor with denatured alcohol, or an equivalent approved brake
cleaner
13. Remove the brake rotor from the brake lathe.
14. Measure the assembled LRO of the brake rotor to ensure optimum performance of the disc brakes. Refer to Brake Rotor Assembled Lateral
Runout Measurement. See: Testing and Inspection/Brake Rotor Assembled Lateral Runout Measurement
15. If the brake rotor assembled LRO measurement exceeds the specification, bring the LRO to within specifications. Refer to Brake Rotor Assembled
Lateral Runout Correction. See: Testing and Inspection/Brake Rotor Assembled Lateral Runout Correction
