Aura V6-3.5L (2007)
Ignition Cable: Service and Repair
Spark Plug Wire Replacement
Removal Procedure
Notice: Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or the
wire could be damaged.
1. Remove the intake manifold cover.
2. Disconnect the left side spark plug wires from the spark plugs.
3. Disconnect the left side spark plug wires from the ignition coil.
4. Remove the spark plug wire clips from the manifold absolute pressure (MAP) sensor bracket and the heater inlet and outlet pipe tab.
5. Remove the spark plug wire assembly.
6. If replacing only one plug wire, open the retaining clips and remove the appropriate spark plug wire.