Aura V6-3.5L (2007)
position of the ignition switch during the programming procedure, unless instructed to do so.
Make certain all tool connections are secure, including the following components and circuits:
^
The RS-232 communication cable port
^
The connection at the data link connector (DLC)
^
The voltage supply circuits
DO NOT disturb the tool harnesses while programming. If an interruption occurs during the programming procedure, programming failure or
control module damage may occur.
DO NOT turn OFF the ignition if the programming procedure is interrupted or unsuccessful. Ensure that all control module and DLC connections
are secure and the TIS terminal operating software is up to date.
1.
Verify the battery charge of 12 to 16 volts. The battery must be able to maintain the charge during programming. Use an additional jump battery if
necessary.
2.
Use the normal "request method" through "Service Programming System" to request information from the vehicle.
3.
At the Techline Terminal, enter TIS SPS programming system.
4.
Select Tech 2(R) from the "Select Diagnostic Tool" window.
5.
Select Reprogram ECU from the "Select Programming Process" window.
6.
Select Vehicle from the "Select ECU Location" window.
7.
Select Next to go to the "Preparing for Communication" instruction screen.
8.
Select Next to view the "Validate Vehicle ID Number" screen. If the vehicle ID number does not appear on the screen, manually insert the VIN
into the VIN window of the "Validate Vehicle ID Number" screen.
9.
Select Next to view the "Supported Controllers" screen.
10.
Select IPC Instrument Panel Cluster from "Supported Controllers" window.
11.
Select Next to view the "Select Programming Type" window.
12.
Select Normal from the "Select Programming Type" window.
13.
Select Next to view the "Service Programming System Calibration Selection" screen.
14.
Select Next to view "Summary" screen.
15.
Verify that current and selected calibration information is displayed on the "Summary" screen.
16.
Select Next to download the calibration to the Tech 2(R).
17.
Back at the vehicle, enter "Service Programming Systems".
18.
Select Program ECU and follow the on-screen instructions.
19.
When programming is complete, do the following:
19.1. Turn the Tech 2(R) OFF.
19.2 Turn the ignition switch OFF.
20.
Wait 30 seconds.
21.
Turn the ignition switch to ON with the engine OFF.
22.
Go into Diagnostics and check for DTC codes.
