Aura V6-3.5L (2007)
Pedal Positioning Sensor: Procedures
Brake Pedal Position Sensor Calibration
Calibration Criteria
The brake pedal position sensor (BPPS) receives a low reference signal and a 5-volt reference signal from the BCM. Whenever the brake pedal is
applied, the BPPS applies a variable voltage signal to the BCM through the stop lamp switch signal circuit. The BPPS calibration must be performed
after the BPPS or body control module (BCM) have been serviced. The calibration procedure will set BPPS home value. This value is used by the BCM
to determine the action of the driver applying the brake system and to provide this information to the vehicle subsystems via the class 2 communication
bus.
Calibration Procedure
* Install a scan tool.
* Turn ON the ignition, with the engine OFF.
* Select Diagnostics.
* Select the Model Year (2007).
* Select Type of vehicle (passenger car).
* Select Product Make (Saturn).
* Select Product Line (Z).
* Select Body.
* Select type Body Control Module.
* Select Module Setup
* Select BPP Sensor Calibration
