Aura V6-3.5L (2007)
Important: Do NOT twist or squeeze the seal during installation and position it in its original position. Ensure the it is properly seated
and inspect the 4 lock tabs from the engine side for any damage. If the intermediate steering shaft seal lock tabs are damaged then replace
the seal.
2. Seat the intermediate steering shaft seal by pushing it forward from the inside of the vehicle until all four lock tabs are fully seated.
3. Connect the intermediate steering shaft to the steering column.
Notice: Refer to Fastener Notice.
4. Install the new intermediate steering shaft bolt.
*
For electronic power steering, tighten the bolt to 49 N.m (36 lb ft).
*
For hydraulic power steering, tighten the bolt to 62 N.m (46 lb ft).
5. Install the left side instrument panel insulator panel.
6. Connect the intermediate steering shaft to the steering gear.
7. Install the new intermediate steering shaft lower bolt.
Tighten the bolt to 49 N.m (36 lb ft).
8. Install the left front tire and wheel assembly.
