Aura V6-3.5L (2007)
Notice: Refer to Fastener Notice.
3. Install the lower control arm to knuckle bolt and nut.
Tighten the bolt and nut to 60 N.m (44 lb ft) plus an additional 70 degrees rotation.
4. Tighten the lower control arm to support bolt and nut.
Tighten the bolt and nut to 110 N.m (81 lb ft).
5. Remove the OTC 204-167 spring compressor and OTC 204-167-01 adapter shoes or equivalent from the vehicle.
6. Remove the jack stand from under the vehicle.
7. Install the rear tire and wheel assembly.
8. Lower the vehicle.
9. Check the rear wheel alignment.
Coil Spring Insulators Replacement
Coil Spring Insulators Replacement