Aura V6-3.5L (2007)
Fluid Line/Hose: Service and Repair
4T45-E - Automatic Transaxle
Transmission Fluid Cooler Pipe Connector Replacement - Radiator
Transmission Fluid Cooler Pipe Connector Replacement - Radiator
Removal Procedure
1. Drain the cooling system.
2. Remove the transaxle oil cooler hoses from the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect
Fitting Disconnection and Connection.
Important: Do not remove the upper and lower transaxle oil cooler fittings from the radiator at the same time other wise the transaxle oil
cooler will fall inside the radiator end tank.
3. Remove the oil cooler fitting from the radiator.
Installation Procedure
1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.
Notice: Refer to Fastener Notice.
Important: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.
2. Install the oil cooler fitting to the radiator.
