Coupe L4-1.9L DOHC VIN 7 (1994)
^
The adaptor terminal must be located at a 2 to 5 o'clock position or if need be, between a 6 and 7 o'clock position. If adaptor terminal is placed
between a 7 and 1 o'clock position, loosening of the battery terminal bolt will occur. (Refer to illustration.)
NOTE:
Do not locate terminal at 6 o'clock position or the terminal seal will be affected.
NOTE:
It is recommended that an additional fuse (30 amp maximum) be installed in the accessory ground lead to prevent possible damage to the accessory,
in the event that the battery to engine block ground is inadvertently disconnected.
^
Battery bolt torque is 17 N.m (151 lbs. in.).
2.
If switched power (ignition) is required for the accessory being installed and the maximum current requirement of the accessory for switched
power does not exceed 8.0 amps from the ignition input:
^
Obtain switched power:
-
For 1991-1994 vehicles, obtain switched power at pin C8, brown wire-circuit 4, of the Brown 46-way connector (P/N 12092939) at the
instrument panel junction block.
-
For 1995 vehicles, obtain switched power at pin F12, brown wire-circuit 4, of the Black 68-way connector (P/N 12146036) at the
instrument panel junction block.
^
Use only 2.0 mm (14 AWG) wire with an in-line fuse (8 amp maximum) placed close to the instrument panel junction block.
^
Refer to the Sub-System Schematics in the Electrical Service Manual for wiring schematics.
^
Perform wire splice using blue crimp and seal connectors (P/N 12089190) according to Wire Repair procedures in the Electrical Service
Manual.
NOTICE:
Do not change any fuse size in the electrical junction blocks (underhood or instrument panel) or damage to wires, electrical junction blocks and/or
components may occur.
3.
When installing any electrical accessory, the parasitic current draw (when the ignition is Off) must be considered. Excessive parasitic current draw
