Coupe L4-1.9L DOHC VIN 7 (1994)
Paint: All Technical Service Bulletins
Paint - Code Information
NO.: 93-I-08
DATE: September, 1993
CORP. NO.: 381508
SUBJECT: 1994 Model Paint Information
TO:
The listings of 1994 paint codes contained in this bulletin will enable Retailers to order the necessary paint materials required for proper field repairs.
The list of colors indicates the suppliers' ordering codes for exterior and interior colors.
All Saturn vehicles are built at the Spring Hill, Tennessee manufacturing facility and painted with a base coat/clearcoat paint process.
Paint manufacturers such as PPG, DuPont, R-M/Glasurit, Sherwin Williams-Martin Senour-Acme and AKZO/Sikkens produce service paint which could
perform satisfactorily for field repairs. Paint suppliers in your area can provide you with information regarding these materials.
The paint listed in this bulletin should be available from local paint suppliers.
The Service Parts Identification (SPID) label illustrated in the Figure is located on the spare tire cover. This label contains the paint codes needed to
identify the paint materials for field repairs. This label identifies the paint code along with the WA # for that paint code. It is important to use this WA #
along with the paint code to identify the correct repair materials. Care should be taken to transfer the SPID label or its information if the panel to which
the label is affixed requires replacement. Replacement SPID labels are not available.
The 1994 Saturn Sedans and Coupes employ composite body panels on the vertical surfaces of the vehicle. The 1994 Saturn Wagons employ composite
body panels on all vertical surfaces and on the roof and tailgate. The following information identifies each type of material, where it is used and the
procedures for painting the types of plastic materials used on Saturn vehicles.
A.
Rigid Plastic Refinishing-GTX, PULSE and SMC
1.
Same procedures as used for sheet metal.
2.
Flex additives are not required when using urethane paint systems.
3.
Avoid lacquer finishes and aggressive solvents and pre-cleaners.
B.
Flexible Plastic Refinishing-TPO
1.
A Polyolefin adhesion promoter such as 3M Polyolefin Adhesion Promoter (P/N 05907) or equivalent is required over all unpainted
