Coupe L4-1.9L DOHC VIN 7 (1994)
4. Torque valve body-to-case bolts using torque sequence shown in the illustration.
Torque: 11 Nm (97 in lbs)
NOTICE: Over-tightening bolts can cause valves to bind.
5. Clean valve body cover gasket surface with carburetor cleaner or equivalent, applied with a shop towel.
6. Set valve body cover gasket in place and instal valve body cover.
7. Torque valve body cover bolts using torque sequence.
Torque: 10 Nm (88 in lbs)
8. Install and torque master cylinder-to-booster nuts, if required.
Torque: 27 Nm (20 ft lbs).
9. Connect transaxle connector.
10. Torque transaxle connector bolt.
Torque: 3 Nm (27 in lbs).
NOTICE: Do not over-tighten or damage to the connector plate may occur.
11. Install battery tray.
12. Torque battery tray bolts.
Torque: 10 Nm (89 in lbs).
IMPORTANT: Two bolts are located in the fender well.
13. Install battery.
14. Install battery shield.
15. Torque battery shield bolts.
Torque: 9 Nm (80 in lbs).
16. Install air induction box.
17. Connect battery terminals
IMPORTANT: It will be necessary to reset the transaxle adaptives before driving vehicle. See: Transmission Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Related Tests and Procedures/Resetting Adaptive Parameters
