saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

A/T - Harsh/Erratic Shifts/No Gear, Multiple Codes|Page 4130 > < A/T - Harsh/Erratic Shifts/No Gear, Multiple Codes|Page 4128
Page 6
background image

The torque converter should be replaced if a hard part (i.e. gear or shaft) failure or a pump failure has occurred in the transaxle.

12.

Assemble the transaxle.

IMPORTANT 

Replace the transaxle suction filter and pressure filter. Wipe the magnet clean with a clean dry rag.

13.

Install transaxle and test drive to verify repair. Refer to test drive procedure in this bulletin.

Test Drive Procedure

After completing the flush procedure or internal inspection, test drive the vehicle using the following procedure.

1.

Clear all PCM codes.

2.

Start vehicle and bring transaxle temperature up to operating temperature of 90° C (194° F).

3.

Shift the vehicle into D2 and start driving:

^

At 32km/h (20 mph), accelerate with 30 percent throttle to 40 km/h (25 mph). Let off on the throttle and decelerate back to 32 km/h (20 mph).
Perform this procedure six times.

^

Read the slip monitor for 2nd clutch.

4.

Shift the vehicle into D3:

^

At 56km/h (35 mph), accelerate with 30 percent throttle to 72 km/h (45 mph). Let off on the throttle and decelerate back to 56 km/h (35 mph).
Perform this procedure six times.

IMPORTANT:

Do not allow a 3-2 downshift. If a downshift occurs, it will be necessary to reduce the throttle slightly.

^

Read the slip monitor for 3rd clutch.

5.

Shift the vehicle into D4:

^

At 64 km/h (40 mph), accelerate with 30 percent throttle to 8O km/h (50 mph). Let off on the throttle and decelerate back to 64 km/h (40
mph). Perform this procedure six times.

IMPORTANT:

Do not allow a 4-3 or 4-2 downshift. If a downshift occurs, it will be necessary to reduce the throttle slightly.

^

Read the slip monitor.

If any of the slip monitor values are greater than zero, internal damage to the transaxle may exist, and the transaxle must be inspected according to the
"Internal Inspection Procedure" in this bulletin.

If all of the slip monitor values are zero, the vehicle is repaired and can be returned to the customer.

Parts and Claim Information

PARTS REQUIREMENTS:
Refer to Service Parts Catalog for any parts replaced.

CLAIM INFORMATION:

A/T - Harsh/Erratic Shifts/No Gear, Multiple Codes|Page 4130 > < A/T - Harsh/Erratic Shifts/No Gear, Multiple Codes|Page 4128