Coupe L4-1.9L DOHC VIN 7 (1994)
a. Loosen door glass guide bolts.
b. Lower the front door glass 25.4 mm (1 in.) from top of window frame.
c. With front door glass fully seated in the rear glass channel and the top edge of the front door glass parallel with the top of the window frame;
snug, then tighten inner panel cam bolt.
Torque: 6 Nm (53 in.lbs.)
d. Lower front door glass to 76 mm (3 in.) from the top position.
e. With front door glass fully seated in the rear glass run channel, adjust the top of front door glass guide so that it is lightly seated against front
edge of front door glass using light rearward pressure.
f. Snug top door glass guide bolt.
g. Lower front door glass to 51 mm (2 in.) from the full-down position.
h. Fully seat front door glass in the rear glass run channel.
Adjust the bottom of front door glass guide so that it is lightly seated against front edge of front door glass using light rearward pressure.
i. Snug bottom and middle door glass guide bolts.
j. Tighten door glass guide bolts.
Torque: 6 Nm (53 in.lbs.)
k. Cycle front door glass to verify proper alignment.
15. Install inner and outer door trim panels.
