Coupe L4-1.9L DOHC VIN 7 (1994)
6.
Remove screw in top of body hinge pillar trim garnish molding on affected side of vehicle.
7.
Starting at rear of body hinge pillar trim gamish molding, pull firmly on molding at clip locations to remove it.
8.
For right-hand side door, install service ring terminal lead (P/N 12112245) at the unused bolt hole, located on the top, inboard corner of the power
window motor housing (where the power window motor attaches to the window regulator assembly). Install service ring terminal lead with
bolt/screw (P/N 21021078).
Torque: 4 N-m (35 in.lbs.)
9.
For left-hand side door, disconnect power window motor. Then install service ring terminal lead (P/N 12112245) at the unused bolt hole, located
on the top, outboard corner of the power window motor housing (where the power window motor attaches to the window regulator assembly).
Install service ring terminal lead with bolt/screw (P/N 21021078). After service ring terminal lead is installed, connect hamess connector to power
window motor.
Torque: 4 N-m (35 in.lbs.)
IMPORTANT:
On left-hand side door, wiring harness connector to the power window motor must be disconnected from the power window motor prior to
installing service ring terminal lead.
