ION L4-2.2L VIN F (2004)
Rear Shelf: Service and Repair
Rear Window Panel Replacement
Rear Window Panel Replacement
Removal Procedure
CAUTION:
-
To avoid personal injury when exposed to welding flashes or to galvanized (Zinc Oxide) metal toxic fumes while grinding/cutting on any
type of metal or sheet molded compound, you must work in a properly ventilated area, wearing an approved respirator, eye protection,
earplugs, welding gloves, and protective clothing.
-
Refer to SIR CAUTION in General Information.
1. Disable the SIR system.
CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads
must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed
electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or
damage to the vehicle or its components.
2. Disconnect the negative battery cable.
3. Remove all related panels and components.
4. Repair as much of the damaged area as possible.
5. Remove the sealers and anti-corrosion materials from the repair area, as necessary.
IMPORTANT: Note the number and location of the factory welds for installation of the rear window panel.
