ION L4-2.2L VIN F (2004)
9. Remove the small trim panel door in the center pillar garnish molding.
10. Feed the seat belt webbing, the anchor bolt, and the D-ring bolt through the center pillar garnish molding.
11. Remove the garnish molding from the vehicle.
INSTALLATION PROCEDURE
1. Feed the seat belt webbing, the anchor bolt, and the D-ring bolt through the opening in the garnish molding.
2. Position the top of the lower center pillar molding beneath the upper pillar molding.
3. Push on the trim clips until the clips engage.
4. Install the door seal over the edge of the garnish molding.
5. Install the small trim panel behind the seat belt webbing.
6. Install the adjustable guide loop webbing bolt.
NOTE: Refer to Fastener Note in Service Precautions.
Tighten the bolt to 45 N.m (33 lb ft).
