ION L4-2.2L VIN F (2004)
1. Feed the seat belt webbing, the anchor bolt, and the D-ring bolt through the opening in the garnish molding.
2. Position the top of the lower center pillar molding beneath the upper pillar molding.
3. Push on the trim clips until the clips engage.
4. Install the door seal over the edge of the garnish molding.
5. Install the small trim panel behind the seat belt webbing.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the adjustable guide loop webbing bolt.
Tighten the bolt to 45 N.m (33 lb ft).
7. Install the height adjuster knob for the seat belt webbings. Refer to Seat Belt Height Adjuster Knob Replacement - Front in Seat Belts.
8. Install the anchor bolt to the front seat belt.
Tighten the bolt to 45 N.m (33 lb ft).