ION L4-2.2L VIN F (2004)
2. Remove the plug from the auxiliary reservoir hose end.
3. Connect the quick-connect fitting on the reservoir hose to the primary reservoir. Ensure that the hose is fully seated to the reservoir.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the brake master cylinder auxiliary reservoir mounting bolts.
-
Tighten the bolts to 10 Nm (89 inch lbs.).
5. Fill the brake master cylinder auxiliary reservoir.
6. Remove the shop towels and discard into an approved container.
7. Connect the electrical connector to the brake fluid level sensor, then press forward on the CPA tab of the connector to secure.
8. Install the cover to the underhood electrical center.
