saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Wheel Cylinder > < Master Cylinder Reservoir Replacement Auxiliary|Page 6689
Page 12
background image

2. If the brake fluid level is at or below the half-full point during routine fluid checks, the brake system should be inspected for wear and possible

brake fluid leaks.

3. If the brake fluid level is at or below the half-full point during routine fluid checks, and an inspection of the brake system did not reveal wear or

brake fluid leaks, the brake fluid may be topped-off up to the maximum-fill level.

4. If brake system service was just completed, the brake fluid may be topped-off up to the maximum-fill level.
5. If the brake fluid level is above the half-full point, adding brake fluid is not recommended under normal conditions.
6. If brake fluid is to be added to the master cylinder auxiliary reservoir, clean the outside of the reservoir on and around the reservoir cap prior to

removing the cap and diaphragm. Use only Saturn P/N 21013073, or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.

Wheel Cylinder > < Master Cylinder Reservoir Replacement Auxiliary|Page 6689