ION L4-2.2L VIN F (2004)
1. Install the exhaust heat shield into position on the vehicle.
2. Install new heat shield retaining rivets.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the exhaust heat shield retaining nut.
^
Tighten the nut to 10 Nm (89 inch lbs.).
4. Remove the support from the exhaust extension pipe.
5. Install the exhaust extension pipe forward insulators to the underbody hangers.
6. Install the catalytic converter pipe to the vehicle.
7. Install the post catalytic converter H02S wiring (1).
8. Lower the vehicle.
