ION L4-2.2L VIN F (2004)
7. Remove the connector position assurance (CPA) from the steering wheel module coil connector.
8. Disconnect the steering wheel module coil connector from the vehicle harness connector.
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. Connect the steering wheel module coil connector to the vehicle harness connector.
3. Install the CPA to the steering wheel module coil connector.
4. Install the left outer trim cover to the I/P.
5. Install the AIR BAG fuse into the body control module fuse center.
6. Install the body control module fuse center cover.
7. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
8. Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check -
Restraint Systems.
