ION L4-2.2L VIN F (2004)
Tighten resistor retaining bolt 10 Nm (89 in-lbs).
15.
Install DRL jumper harness connector into the resistor connector and the forward lamp harness connector on each side.
16.
Secure jumper harness to vehicle using clip on connector to forward lamp harness on each side.
Important:
Perform steps 17-21 on all vehicles.
17.
Position each headlamp assembly in its respective vehicle opening and connect remaining headlamp wiring harness connector to connector on the
headlamp assembly.
18.
Install each headlamp assembly into its respective headlamp bracket and install headlamp assembly retaining pins by pushing down on the pins.
19.
Clear diagnostic trouble codes (DTCs) from body control module (BCM) using Tech 2 scan tool.
20.
Activate left and right turn signal to verify proper operation.
21.
Close the hood.
