ION L4-2.2L VIN F (2004)
9.
Connect the other end of the negative (-) cable at least 18 inches (45 cm) away from the dead battery, but not near engine parts that move. The
electrical connection is just as good there, and the chance of sparks getting back to the battery is much less. Refer to appropriate model year below
for correct negative location.
^
For 2003 and 2004 model year vehicles, attach the black negative (-) cable to the engine lift hook of the dead battery vehicle, about 18 inches
(45 cm) away from the remote positive (+) terminal, but not near engine parts that move.
^
For 2005 and 2006 model year vehicles, attach the black negative (-) cable to the remote negative terminal. The remote terminal is located
under the GND (-) sticker on the driver side of the radiator support bar (near hood prop rod).
10.
Now start the vehicle with the good battery and run the engine for a while.
11.
Press the unlock button on the remote keyless entry transmitter to disarm your security system, if equipped.
12.
Try to start the vehicle that had the dead battery. If it will not start after a few tries, it probably needs service.
Note:
If the jumper cables are connected or removed in the wrong order, electrical shorting may occur and damage the vehicle. The repairs would not
be covered by your warranty. Always connect and remove the jumper cables in the correct order, making sure that the cables do not touch each
other or other metal.
13.
Disconnect jumper cables.
13.1. Disconnect the black negative (-) cable from the vehicle that had the dead battery.
13.2. Disconnect the black negative (-) cable from the vehicle with the good battery.
13.3. Disconnect the red positive (+) cable from the vehicle with the good battery.
13.4. Disconnect the red positive (+) cable from the other vehicle.
13.5. Return the red protector cap to its original position.
Claim Information
To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System for N1720 (Fuse - Replace).
