ION L4-2.2L VIN F (2004)
Steering Gear: Service and Repair
Rack and Pinion Boot Replacement - On Vehicle
Rack and Pinion Boot Replacement - On Vehicle
-
Tools Required
-
SA9164C Clamp Pliers
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the front wheel.
3. Remove the outer tie rod end.
4. Remove the outer to inner tie rod jam nut and discard.
5. Remove the outer steering gear boot spring clamp.
6. Using cutters, cut the inner steering gear boot clamp, remove and discard.
7. Disengage the Steering Gear boot from the steering gear and remove over the inner tie rod.
8. Inspect the sealing surfaces and threaded shaft portion of the steering gear and inner tie rod. The surfaces must be clean and free of debris.
Installation Procedure