ION L4-2.2L VIN F (2004)
2.
Locate metal transaxle identification tag (1), and identify the transaxle part number (4). The transaxle part number will be needed to reference the
calibration information table shown for the correct calibration identification.
Important:
For reprogramming procedures, refer to the Service Programming System (SPS) in SSS Users Guide.
3.
Reprogram the transaxle control module (TCM) with updated calibration established from the calibration information table in this bulletin. Use
Saturn Service Stall (SSS) software release TIS 03/2004 or later data CD.
Important:
Failure to relearn the TCM may cause intermittent erratic shifts, customer dissatisfaction, and a return visit to the store.
Important:
Perform all steps of the adaptive learn procedure. Engine flare during shifting or harsh shifts may occur if not done correctly. When
performing the 2-3 and 3-4 up-shifts, a small shift flare may occur the first or second time depending on transaxle internal tolerances.
4.
Drive the vehicle until the transaxle fluid temperature reaches 65°-110°C (150°-230°F). The adaptive learn procedure will only work when the
transaxle fluid temperature is correct.
5.
Reset the transaxle adaptive learns using the Tech 2(R) Scan Tool. Go to the Transmission Special Functions, then Trans. Output Controls menu
and select Reset Transmission Adapts.
6.
Perform the following steps for the garage shifts adaptive learn.
6.1.
Apply the parking brake and the foot brake.
6.2.
Shift from NEUTRAL to REVERSE and keep in REVERSE for 3 seconds.
6.3.
Shift from REVERSE to NEUTRAL.
6.4.
Repeat Steps 6.2 and 6.3 five times.
6.5.
Shift from NEUTRAL to DRIVE and keep in DRIVE for 3 seconds.
6.6.
Shift from DRIVE to NEUTRAL.
6.7.
Repeat Steps 6.5 and 6.6 five times.
7.
Perform the following steps for the up/down shifting adaptive learn.
7.1.
Drive the vehicle in DRIVE with light (15-20%) throttle until above 50 km/h (31 mph) in 4th gear.
7.2.
Decelerate and apply the brakes until vehicle comes to a stop. Brake the vehicle so that it takes at least 14 seconds to come to a stop.
7.3.
Repeat Steps 7.1 and 7.2 five times.
7.4.
Drive the vehicle in DRIVE with medium (50-55%) throttle until vehicle shifts into 5th gear. (Vehicle speed will exceed 105 km/h [65 mph]
for this shift.)
7.5.
Decelerate and apply the brakes until vehicle comes to a stop. Brake the vehicle slowly so that each downshift occurs.
7.6.
Repeat Steps 7.4 and 7.5 five times.
8.
Perform the following steps for 2-1 manual down shift adaptive learn.
8.1.
Drive the vehicle in INTERMEDIATE range until over 25 km/h (16 mph) in 2nd with any throttle position.
8.2.
Decelerate, shift from INTERMEDIATE range to LOW range manually and stop the vehicle.
8.3.
Repeat Steps 8.1 and 8.2 ten times.
Important:
If shift quality does not improve, verify that the TCM has the correct transmission calibration.
9.
Confirm shift quality.
