ION L4-2.2L VIN F (2004)
Notice: Refer to Fastener Notice in Service Precautions.
2. Tighten the rear transaxle mount to fame bolts.
^
Tighten the bolts to 60 Nm (44 ft. lbs.).
Important: Rotate the rear transaxle mount heat shield clockwise until the tab is seated on the mount bracket.
3. Hand start the rear transaxle mount through bolt
Important: The front and rear transmission mounts must be allowed to settle with the through bolts loosened.
4. Loosen the front trans mount through bolt.
5. Tighten the transmission mount through bolts in the following order.
5.1.
Tighten the rear bolt to 100 Nm (74 ft. lbs.).
5.2.
Tighten the front bolt to 100 Nm (74 ft. lbs.).
6. Lower the vehicle.
